Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
David loom tie-ups
The David loom is a sinking shed jack loom, so the shafts are pulled down. In most weaving drafts, the shaft that is raised are the shafts that are indicated in the tie up graph.In order to see y...
-
Delta relevant measurements and information
Loom Dimmensions Delta 110 - 140 x 100 x 128 cm (55′′ x 39 3/8′′ x 50 3/8′′) Delta 130 - 160 x 100 x 128 cm (63′′ x 39 3/8′′ x 50 3/8′′) Folded 76 cm (30′′) deep Weight Delta 110-8 ...
-
Extra (3rd) Tie on rod
The metal rod tie-on rods shown in the Jane loom warping instructions and on some warping videos we have produced, are rods used in these warping techniques. The Jane warping instructions were w...
-
Octado Interface Instructions - June 2014
Here instructions pertain to interfaces delivered June 2014 and later. These interfaces are made in Holland.
-
Spinning Wheel S90 product information
General information ... Funfact From Jan Louet, founder and primary designer of all Louet equipment: When, I was designing the S90, my son Jop, 16 years old, was doing a holiday job in our facto...
-
David Loom is a “sinking shed jack” – does that mean that it is a counterbalance loom?
The David Loom is a sinking shed loom but it is not a counterbalance loom. Counterbalance looms work with 2 sets of rollers. When you tie-up a treadle to any combination of shafts then you have an ...
-
Octado original Electronic Dobby Instructions
These apply to Octado dobby's purchased prior to 2014
-
Megado - How to replace a knife Texsolv cord on the Megado
See pdf - Sometimes the texsolv cord that lowers the knife bar can fray and brake. Use these instructions to resolve
-
David - Squeaky sound
What you are hearing is new metal on wood and it just needs some non oily lubricant - best to use dry Teflon spray (PTFE spray). The source of the squeaking can be at the cams at the top right of t...
-
Octado breast beam height
What is the height of the Breast Beam for the Octado? 36 1/2 inches