Team Louët @ Louet Support
- Total activity 544
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Ball winder tips
The New Louet Ball Winder (July 2025) has a wooden base that is finished to the standards of Louet woodworking.Note there are a few adjustments that can be made if your Ball Winder stops performing...
-
Jenn-E brake issue in ScT
I am loving my new Jenn-e. But I keep breaking the cotton band in scotch tension. Any ideas on how to solve this?Louet prefers cotton over nylon brake cord, however, if there is any roughness on yo...
-
Olivia S80 spinning wheel manual
Here is the Olivia manual
-
Dobby 2.0 keeps disconnecting from my device
This issue is more commonly that a device is searching for an internet connection. The Louet wifi does not provide an internet connection, thus, if your device is set to always connect to the stron...
-
Jane 2nd Warpbeam instructions
Here are the Current Jane 2nd warp beam instructions (May 2025)
-
Jane feet length and harness / shaft height from the table during setup
In 2024 we added a shuttle race for Jane 50, 70 and eventually Jane 90. With this accessory, we discovered that the loom will not sit on a table folded due to interference with the shuttle race....
-
E- spinner lubrication - Jenn-E
If your Jenn-E is squeaking, add some vaseline (liberally) to the orifice and orifice support. The more you spin and lubricate, the less it will squeak.
-
Jenn- E battery options - E-spinner
The new Louet E-spinner can be operated with a battery. The battery you need is a 10-18V and 15Ah battery. This size will give you about 15 hour of spinning time. This is a bigger battery th...
-
Moving a David or Spring loom
The back beam section can be folded to the castle after loosening the two eye bolts. If there is a warp on the loom, tightening the warp keeps the back beam in place.If not, use some cord or rope ...
-
Floating breast beam vertical is not equal on left and right side
We recommend setting up the verticals so they are flush with the front leg of the loom for quick and easy reference when you advance your warp. However, sometimes, even with the same number of ex...