Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Activity overview
Latest activity by Team Louët @ Louet Support-
Team Louët @ Louet Support created an article,
-
Team Louët @ Louet Support created an article,
David 1 & 2 Manuals
Here are the manuals from the discontinued David 1 and David 2 models
-
Team Louët @ Louet Support created an article,
Erica Floorstand
The Erica floorstand is an accesory for both the 30cm and 50 cm Erica Table looms. It comes with a cross bar for both looms. The metal supports are product BT0003.
-
Team Louët @ Louet Support created an article,
Ball winder tips
The New Louet Ball Winder (July 2025) has a wooden base that is finished to the standards of Louet woodworking.Note there are a few adjustments that can be made if your Ball Winder stops performing...
-
Team Louët @ Louet Support created an article,
Jenn-E brake issue in ScT
I am loving my new Jenn-e. But I keep breaking the cotton band in scotch tension. Any ideas on how to solve this?Louet prefers cotton over nylon brake cord, however, if there is any roughness on yo...
-
Team Louët @ Louet Support created an article,
Olivia S80 spinning wheel manual
Here is the Olivia manual
-
Team Louët @ Louet Support created an article,
Dobby 2.0 keeps disconnecting from my device
This issue is more commonly that a device is searching for an internet connection. The Louet wifi does not provide an internet connection, thus, if your device is set to always connect to the stron...
-
Team Louët @ Louet Support created an article,
Jane 2nd Warpbeam instructions
Here are the Current Jane 2nd warp beam instructions (May 2025)
-
Team Louët @ Louet Support created an article,
Jane feet length and harness / shaft height from the table during setup
In 2024 we added a shuttle race for Jane 50, 70 and eventually Jane 90. With this accessory, we discovered that the loom will not sit on a table folded due to interference with the shuttle race....
-
Team Louët @ Louet Support created an article,
E- spinner lubrication - Jenn-E
If your Jenn-E is squeaking, add some vaseline (liberally) to the orifice and orifice support. The more you spin and lubricate, the less it will squeak.