
Dave @ Louet Support
- Total activity 549
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 301
Activity overview
Latest activity by Dave @ Louet Support-
Dave @ Louet Support created an article,
Jenn-E brake issue in ScT
I am loving my new Jenn-e. But I keep breaking the cotton band in scotch tension. Any ideas on how to solve this?Louet prefers cotton over nylon brake cord, however, if there is any roughness on yo...
-
Dave @ Louet Support created an article,
Olivia S80 spinning wheel manual
Here is the Olivia manual
-
Dave @ Louet Support created an article,
Dobby 2.0 keeps disconnecting from my device
This issue is more commonly that a device is searching for an internet connection. The Louet wifi does not provide an internet connection, thus, if your device is set to always connect to the stron...
-
Dave @ Louet Support created an article,
Jane 2nd Warpbeam instructions
Here are the Current Jane 2nd warp beam instructions (May 2025)
-
Dave @ Louet Support created an article,
Jane feet length and harness / shaft height from the table during setup
In 2024 we added a shuttle race for Jane 50, 70 and eventually Jane 90. With this accessory, we discovered that the loom will not sit on a table folded due to interference with the shuttle race....
-
Dave @ Louet Support created an article,
E- spinner lubrication - Jenn-E
If your Jenn-E is squeaking, add some vaseline (liberally) to the orifice and orifice support. The more you spin and lubricate, the less it will squeak.
-
Dave @ Louet Support created an article,
Jenn- E battery options - E-spinner
The new Louet E-spinner can be operated with a battery. The battery you need is a 10-18V and 15Ah battery. This size will give you about 15 hour of spinning time. This is a bigger battery th...
-
Dave @ Louet Support created an article,
Moving a David or Spring loom
The back beam section can be folded to the castle after loosening the two eye bolts. If there is a warp on the loom, tightening the warp keeps the back beam in place.If not, use some cord or rope ...
-
Dave @ Louet Support created an article,
Floating breast beam vertical is not equal on left and right side
We recommend setting up the verticals so they are flush with the front leg of the loom for quick and easy reference when you advance your warp. However, sometimes, even with the same number of ex...
-
Dave @ Louet Support created an article,
S20 wheel
There have been two versions of the S20. From 1977 to 1979 there was a special export version of the S10, which could be disassembled so that it could be sent as a flat package. After that, the S10...