Ineke Elsinga | Louët BV
- Total activity 231
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 0
- Subscriptions 201
Activity overview
Latest activity by Ineke Elsinga | Louët BV-
Ineke Elsinga | Louët BV created an article,
S10 Concept extra accessories
Part# / artikelnummer Description Beschrijving SA0140 Bag / Tas Bag S10C The S10C is easy to disassemble. All parts will fit in this bag. The bag is reinforced and has an ex...
-
Ineke Elsinga | Louët BV created an article,
Delta - Assembly instructions
In the attachment, you will find the Delta assembly instructions.
-
Ineke Elsinga | Louët BV created an article,
David 3 - Inserting or removing the shaft blocking pin
The David-3 shaft blocking pin blocks shaft movements and levels the shafts. This is convenient when threading the warp threads and when tying the treadles. The first series of the David-3 delivere...
-
Ineke Elsinga | Louët BV created an article,
David 3 - Shaft system described
Download the article attached that explains how the shafts operate and how they can be adjusted.
-
Ineke Elsinga | Louët BV created an article,
David 3 - Adjusting beater height
The David shed is created by pulling shafts down. The optimal shed is created with the lower shed lying on the shuttle race so that your shuttle slides smoothly over it. Also check whether the ...
-
Ineke Elsinga | Louët BV created an article,
David 3 - Adjusting shaft heights
For the David to function properly, it is important that the shafts and the beater are properly adjusted to an optimal height. These instruction are not clear in the first version of the manu...
-
Ineke Elsinga | Louët BV created an article,
Octado - setting the mechanical dobby transport cord tension
If the tension on the cords of the mechanical dobby is not properly set, the transport of the dobby pattern heddles may jam in the forward and/or backward direction. It can also happen that the bra...
-
Ineke Elsinga | Louët BV created an article,
Fiber is difficult to feed into the orifice, what should I do
Possible causes: You are holding the fiber supply too tightly. The twist has reached the fiber supply, possibly due to too much twist. Make sure that the twist does not extend past your fingers of...
-
Ineke Elsinga | Louët BV created an article,
Hard to treadle my spinning wheel
Possible causes: Your brake is set too tight --> loosen the leather (Irt) or the brake belt (Sct) The yarn is not threaded correctly in your flyer You are spinning thick or too irregular yarn with...
-
Ineke Elsinga | Louët BV created an article,
Spinning tension or pull - how to increase/decrease - How Louet wheels spin yarn
By slowing down the flyer (Irish tension) or the bobbin (Scotch tension) you can better control the tension on the spun yarn. With Irish tension spinning wheels, the twist is caused by the spinning...