Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Spring / David / Jane bench
The bench was re-designed in 2012 giving it a larger seat surface area. Seat area is 23.5” x 9.5 “ Height 22.5” Feet have a foot print of 14.5” x 18.5”
-
Megado Dobby 2.0 - solving connection problems
If the Megado Dobby 2 does not seem to work properly, and restarting the computer and the dobby does not solve the problem, the next step is to check the hardware. It’s most common that a dobb...
-
Spinning Wheel - Bobbin Bearings
What is a Bobbin Bearing Louet bobbins have a large center core. In order to allow the bobbin to rotate smoothly on a flyer shaft, we use a molded plastic bearing called a "Bobbin Bearing" Bobb...
-
Spring 1 - nuts slipping off end of harness bar
The issue is that the nut on the threaded part of the harness end slides off the threading, basically getting stripped off. The result is the nut falls out of the holder with the nut ending up on ...
-
Megado Dobby 2 web interface user manual version 2.2
Attached is the new user manual release in May 2020
-
Beater adjustment
This applies to the Megado, Spring, Spring II, David III, Delta, Octado, Hollandia Vertical adjustment:To ensure that the reed strikes the fell line straight,, it is important to adjust the reed ...
-
Spring - Loom treadles make noise
There are a variety of reasons why this could happen - it is possible and within expected tolerance. Generally, you can expect some sound generated when operating the treadles. There are some a...
-
Megado Dobby2 Software 2.2 manual
The Louet dobby software is offered on Megado electronic dobby units as of 2018. The purpose of this software is to provide a wireless method of operating the Megado dobby, but it is not meant to...
-
Spinning Wheel - Footman to Treadle Connector
The Footman to treadle connector is the connection between the footman and the treadle. It is a 2" long piece of Polyurethane tube. It’s flexible and connected to each end with a screw. These are a...
-
Spring 2 - Harness drop when you remove the blocking pin / weaving with 2-4 shafts
The Spring 2 has 2 harnesses and 1 lam attached to the outside texsolv cord. This makes the weight differential imbalanced and without any other forces acting, harnesses have a tendency to drop....