Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Spinning Wheel - Wheel maintenance for all IrT Louet wheels before the S10 concept
The attached info was written before Louet offered Scotch Tension systems, so some of the information pertains to IrT - Bobbin Lead systems only. Information regarding bearings, wobbly wheels ar...
-
Jane loom floor stand - how do I add the warp beam to the stand?
Moving the beams to the floor stand/Verplaatsen van de bomen naar het onderstel E This drawing shows how the warp should be connected to the beams in the floor stand. E Remov...
-
Floor looms - what is the blocking pin used for
You can block the shaft movement by applying the blocking pin. The blocking pin is used to stabilize the harnesses for threading and the tieup of the treadles. When the locking pin is fitted, the s...
-
Magic Dobby 2nd warpbeam
Here are the instructions for the Magic Dobby 2nd warpbeam
-
Jane loom warp length?
How big of a warp can the Jane loom hold? If your warp is fine like 2/8 cotton you could put on a 8-10 yd. warp. If it is heavier like 4 ply wool, I think you could get on a 6-7 yd. warp easily. Th...
-
Megado, Octado, Magic - USB to Serial driver
Drivers for Louet Dobby2 and Interfaces Current dobby2 and Interfaces, newer than 2014 ftdi driver windows 10/11 A FTDI driver for mac is not needed on newer macs. if you upgraded your mac from an...
-
Parallel Countermarche system - Spring / Delta / Hollandia
The Louet Hollandia, Spring and Delta are equipped with Louet's unique parallel countermarch system. How a traditional parallel countermarch works In the diagram, S are the marked pivot points ...
-
Megado and Octado - Adjusting Dobby Hook height
check first this article Megado harnesses are sticking The screws in the clamps have a Phillips head, so the screwdriver that is supplied with the loom will not fit properly, but most cross head s...
-
Floating Breast beam
The floating breast beam is a system patented by Louet to ensure equal warp tension each time you advance your warp. This system is available on our Spring, Delta, Octado and Megado looms. Here...
-
Octado Assembly Manual
Octado Assembly Manual