Adjusting Shaft and Lam heights Spring 2 / Spring 1 / Hollandia / Delta -

Before adjusting your harness or lam heights, always insert the blocking pin

Fine tuning height

The end of the shaft bar and lam bars have a nylon knurled nut screwed onto a plastic bolt.   The plastic bolt has a connection point which is inserted into the texsolv cord.    The length of the bolt is about 5 cm (app 2").   By turning the knurled nut up or down, you can raise or lower the harness bar or lam bar.   

Gross height adjustment

If you need to adjust the height by more than turning the knurled nut allows, you need to move the bolt hook to the next loop in the texsolv cord and then go back and fine tune.    Since the cord is under tension, inserting the bolt into the cord can be more difficult.    you can move the texsolv peg at the top of the castle by one or two positions to reduce the tension, HOWEVER, make note of the loop used to originally fix the texsolv peg.   you will need to tighten and re-insert the peg into the same hole once the operation is complete