Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Junior Carder
General information and usage video for the Standard Louet Carder
-
Drum Carder Instructions
This is the original instructions for Louet Drum Carders
-
David III / David 3 - assembly instructions
July 2023 A new David III assembly video and download the new improved assembly manual with user instructions. Improvements David III July 2023: Locking nuts on the lam cords - locking nuts are u...
-
Spinning wheel - Double Treadle wheel clicks while treadling
This applies to all DT wheels Question: I have a double-treadle, and it makes a clicking noise when the right treadle goes down. It's taken me a while to figure out the source of the noise, but I f...
-
Jane 8 relevant measurements and information
Jane 8 shaft information (original 8 shaft only) Loom Dimensions Jane 40 - 57 x 75 x 65 cm (22 3/8′′ x 29 1/2′′ x 25 5/8′′) Jane 50 - 67 x 75 x 65 cm (25 1/8′′ x 29 1/2′′ x 25 5/8′′) Jan...
-
Victoria - High Speed Set
Instructions and general information Push the small whorl as far as it will go on the front of the whorl shaft. I recommend using a socket or pipe with the same diameter as the pulley to prevent cr...
-
A shaft is slanted - Megado
See this Article - Megado - a shaft is slanted
-
Victoria - Footman Bolt Assembly
The footman bolt assembly on the older version (circa 1998) of the Victoria was attached with a screw. Some times, when you ply long enough the screw would eventually start unscrewing and come out....
-
General - My Loom Squeaks
Depending on use and climate a loom can start squeaking. Use Dry Spray teflon lubricant Megado Megado can start squeaking, usually from the knife bar groove. Spray it in the knife bar groove, on b...
-
Lisa Loom Instructions
Download the instructions for the Lisa Loom: The instructions for the Lisa Small differ from those for the medium, large, and extra-large.