Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
David 3 - sticking shaft
If your new David 3 has a shaft or two that do not want to return without help - ie, push the treadle and the treadle stays down - try increasing the spring tension under the shelf. This can also o...
-
Megado - harness end keeps coming loose
We have had some users report problems with the wire harness ends coming out of the harness bars even though the user has pushed them fully together. The hole in the harness bar is drilled at a sli...
-
S51 Product Information
The S51 was made in the 1990’s. It is essentially the same as an S10 but the main wheel has 6 spokes. It uses all the same accessories as the S10 Here is a list of common accessories available ...
-
Spring 2 Leg System
Louet has developed a system to lift the Spring loom off the floor by approximately 14” so that a weaver can more easily do the tie ups without crawling. It’s is product # WA0416 and can be order...
-
Victoria - Flyer disconnects while spinning
Some Victoria owners have experienced their flyers disconnecting and falling off while spinning. There are a couple reasons why this can happen. Your flyer was not locked in properly and engaged t...
-
Erica relevant measurements and information
Loom Dimensions Erica 30 - 42 x 62 x 42 cm (16 1/2′′ x 24 1/2′′ x 16 1/2′′) Erica 50 - 62 x 62 x 42 cm (24 1/2′′ x 24 1/2′′ x 16 1/2′′) Folded 16 cm (6 1/4′′) high Included with the loo...
-
IrT wheel - Footman bearing is stuck in footman cup - screw or bolt is sticking out.
As seen in the image below, the bolt has come undone. You may alternatively have a screw connection where the screw is sticking out instead of a bolt. Solution: Hold the bolt or screw with a pa...
-
IrT spinning wheel - Flyer rod has grooves grinding into the rod - S17, S10, S51, S77
This article applies to all IrT (Irish Tension) Louet wheels. Spinning generates fiber dust and grit and when/if this dust and grit get into the flyer bearing, the friction of the rotating flyer ro...
-
Double Row mini combs
Here are the instructions for Double Row minicombs
-
Drum Carder - Do I need to take my Drum Carder apart to clean it?
NO! The Louet Standard, Classic and Junior roving carder, all have an enclosed gearbox to keep fiber, grit and dirt out of the moving parts of the carder. Under most common use, there is no need to...