Team Louët @ Louet Support
- Total activity 547
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Springs from my brake keep falling off - Spring 2 / David 3
If your brake tension system springs keep falling off when you release your brake tension, try changing how you release the brake. By lifting the brake handle, one of the springs stretches and on...
-
Louet Bobbins
The current S10 bobbin will fit on all older single treadle or double treadle wheels of the past except a couple. SA0102 is the standard IrT S10 bobbin and fits on S10, S10C, S51, S70, S71, S75, ...
-
S30 - Original Louet Electric Spinner
Louet made an E-spinner back in the 1970's, before they were popular. Some of these units are still in circulation. Here is some information that came with them
-
David 3 breast beam height
David 3 breast beam is 29 1/4" from floor to the bottom of the beam and 31 ½” to the top of the beam
-
Jane - loose threads at the bottom of the shed
With linen and other yarns that are not very elastic, it is sometimes a problem to get good tension on the lower half of the shed on the Jane-loom. Because the depth of the Jane is so great, the pr...
-
Erica shafts cords are slipping
This article applies to our new plastic shaft sides (april 2023) If your shafts are slipping and the bolt does not seem to hold the cord tight, this is likely because the cord is slipping beside th...
-
Original S10 Skeinwinder
Here are the original instructions showing parts and hardware needed
-
Megado - Changing the texsolv of the Knife Bar
Watch the video below for the instructions.
-
Adjusting Shaft and Lam heights Spring 2 / Spring 1 / Hollandia / Delta
Before adjusting your harness or lam heights, always insert the blocking pin Fine tuning height The end of the shaft bar and lam bars have a nylon knurled nut screwed onto a plastic bolt. The p...
-
Table clamp
Our table clamps - KR0120 p have an 8mm diameter. Years ago, the clamp was metal with a 6mm bolt. If you have an older Drum Carder with a 6mm hole for the clamp and you need a new clamp, you can...