Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Knife bar on my Megado is getting stuck in the groove
The groove where your Megado knife bar travels can become swollen due to humidity or contract due to a dry climate. This is simply something that can happen to wood. Use some Sandpaper to smoo...
-
David 2 - Beater repair kit
The original David 2 sliding beater has an open side on the top beater bar. Some weavers find that the retaining bolt slips out of the groove preventing the reed from being held firmly in place. ...
-
Spring / Delta - How many tie up cords come with my loom?
Louet supplies sufficient tie up cords to tie-up 2/3 of the possible lam tie up positions on these countermarche looms. The reason for this is that on the vast majority of balanced weave structur...
-
how does Louet’s drum carder function
The carding action happens because wool is introduced to the 2 drums that are moving at different speeds and the cloth is moving in opposite directions. The difference in size of drum is needed t...
-
Beater Guide for Megado
Instructions for assembly
-
David 3 / Spring 2 - tie up cords get caught on each other
The David 3 tie up cords have been known to catch on one another. In order to solve this, we have used smaller head screws and we routed out a groove to set the screw heads in. This eliminates...
-
Victoria S95/S96 Instruction Manual
Attached is the instruction manual for the Victoria wheel Here are some common spareparts Accessory Part number Standard Bobbin SA0104 brake cord - nylon cord and spring SR0102 brake...
-
David 3 / Spring 2 - Beater arm is rubbing on the side of the loom
If you are experiencing that your beater seems to rub on one side of the loom when it is moved, your beater hinges - hinge hooks, are likely set to different height positions. To resolve, meas...
-
Spring 2 / David 3 - tie up cords catch on each other - how do I resolve this ?
There was some early feedback that treadle cords (tie up cords) were catching on each other, therefore we added a groove to eliminate that possibility. Basically, screw the screws in so they are ...
-
David 3 / Spring 2 - Shed is small - beater is too high
When assembling either of these looms, you set the beater height randomly and it is usually too high and usually needs to be adjusted. If the bottom shed is being deflected upwards by the beater ...