Team Louët @ Louet Support
- Total activity 543
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Spring Loom Shed is small
Check if you have tied up the treadles properly: when shafts 1-3-5-7 go up, the treadle screws 1-3-5-7 must be connected to the lower lam with the short cords. The treadle screws 2-4-6-8 are then...
-
Hollandia Loom Product Info
In 1985 Louet introduced its first floor loom - the Hollandia which boasted a unique parallel countermarache system. It was made in 110 or 130 cm (43.5” or 51.5”) weaving widths with a choice of...
-
Spring1 - beater height - shed is too small
If the beater is sitting too high, you will see a bend in your warp threads immediately behind the beater as the threads are being stretched. This bend is reducing your shed. Go to the bottom of th...
-
Spinning wheel - How to change a bearing in Louet wheel backpost
-
Vertical warping mill instructions
A new version of the vertical warping mill was put into production in 2024. The central axle now runs on a ball bearing, which guarantees that it will run smoothly. The warping mill can be folded ...
-
Spring / Delta loom neutral position - harnesses do not go back to a rest position
Jack looms always return to a “rest” position after a treadle is released. Countermarche looms behave differently. The Spring loom is a parallel countermarch: The weight of the shafts and the u...
-
Instructions for Horizontal Warping Reel / Yarn Blocker
Attached are the instructions for the Louet Warping Reel, which can also be used as a Yarn Blocker. This product was discontinued approx 2008
-
Delta/Spring - Upgrading harness ends to current version
In 2019 Louët changed the mechanism for attaching harness ends on the Spring 1 and Delta looms. If you have a Spring 1 loom from earlier years, you can upgrade your harness ends (Part # WR0182)....
-
Warp Tension regulator instructions
Used to manage warp tension and warp sectionally. Aid for warp tension and counter for warp tension regulator are recommended. Counter is available in metric and imperial
-
Spinning wheel - replacing a footman on an original S10 Louet wheel
In VERY early model S10's, the footman itself and its connection to the main wheel was not a ball bearing system. You can replace the footman and have a connection that runs on a bearing. Your...