Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Victoria / S10dt - Squeaking noise coming from double treadle area
Louet Double Treadle Wheels There is a small axel at the center of the rocker arm. (The rocker arm is the wooden dowel that connects the two treadles) There is a plastic bushing that sits inside...
-
General - Are heddles included in harness extension sets
Question: Are heddles included in harness extension sets? Answer No, Louet does not supply additional heddles in shaft extension sets. You do need to order any additional heddles you may wish. ...
-
Erica loom weaving and assembly instructions
2023 The shaft sides of the Erica have been upgraded: instead of wood, it is now a stronger injection molded plastic. The instructions below replace the instructions in the manual for ‘Assembling t...
-
General - Warp beam / cloth beam is hard to turn.
We have found that some climates can either dry or swell the holes in the wooden supports that holds the cloth and warp beams. Read this article: Algemeen - Scheringboom met frictierem komt niet l...
-
Victoria / ScT - white orifice insert is missing
The flyer orifice inserts are available separately as a spare part. You can order from any Louet retailer - ask for part # SR0127
-
Jane - loom floorstand bolt
The bolt that attaches the Jane or Kombo o the floorstand is a 6mm x 135mm threaded rod. In the stand, a 6mm barrel nut is used. On top of the loom, a 6mm washer and 6mm cap nut is used to secure t...
-
General - Friction Drum Brake does not release
We have found that some climates can either dry or swell the holes in the wooden supports that holds the cloth and warp beams. The solution is to disassemble the beam completely and inspect the ...
-
Klik loom instructions
Klik loom instructions
-
Victoria - Unstable backpost
Unstable backpost The Victoria is unique in the way it folds with a pull pin and click locking system. However, there is a way to fine tune how snug that pull pin system operates. If it is too ...
-
General - My Warp tension keeps coming loose?
The best way to see if the problem is the brake or your warping is to see if you can move the warp beam with your hands without stepping on the brake. If you can move the warp beam, then you need...