Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
David 3 / Spring 2 - tie up cords get caught on each other
The David 3 tie up cords have been known to catch on one another. In order to solve this, we have used smaller head screws and we routed out a groove to set the screw heads in. This eliminates...
-
Victoria S95/S96 Instruction Manual
Attached is the instruction manual for the Victoria wheel Here are some common spareparts Accessory Part number Standard Bobbin SA0104 brake cord - nylon cord and spring SR0102 brake...
-
David 3 / Spring 2 - Beater arm is rubbing on the side of the loom
If you are experiencing that your beater seems to rub on one side of the loom when it is moved, your beater hinges - hinge hooks, are likely set to different height positions. To resolve, meas...
-
Spring 2 / David 3 - tie up cords catch on each other - how do I resolve this ?
There was some early feedback that treadle cords (tie up cords) were catching on each other, therefore we added a groove to eliminate that possibility. Basically, screw the screws in so they are ...
-
David 3 / Spring 2 - Shed is small - beater is too high
When assembling either of these looms, you set the beater height randomly and it is usually too high and usually needs to be adjusted. If the bottom shed is being deflected upwards by the beater ...
-
David 3 - sticking shaft
If your new David 3 has a shaft or two that do not want to return without help - ie, push the treadle and the treadle stays down - try increasing the spring tension under the shelf. This can also o...
-
Megado - harness end keeps coming loose
We have had some users report problems with the wire harness ends coming out of the harness bars even though the user has pushed them fully together. The hole in the harness bar is drilled at a sli...
-
S51 Product Information
The S51 was made in the 1990’s. It is essentially the same as an S10 but the main wheel has 6 spokes. It uses all the same accessories as the S10 Here is a list of common accessories available ...
-
Spring 2 Leg System
Louet has developed a system to lift the Spring loom off the floor by approximately 14” so that a weaver can more easily do the tie ups without crawling. It’s is product # WA0416 and can be order...
-
Victoria - Flyer disconnects while spinning
Some Victoria owners have experienced their flyers disconnecting and falling off while spinning. There are a couple reasons why this can happen. Your flyer was not locked in properly and engaged t...