Spinning Wheel - Footman to Treadle Connector

The PU treadle connector is the flexible connection between the footman and the treadle. It is made from an 8 mm round polyurethane cord.

Over time, depending on use and climate conditions, this part may wear out or break. Fortunately, it is easy to replace.

Parts

• SR0112 – Standard (fits most wheels)
• SR0113 – S90
• SR0114 – Victoria S95/S96

Note: the S90 and Victoria use a different shape.

Tips

• Tip 1: On wheels with ball bearings, you can detach the footman for easier access.
• Tip 2: If it is difficult to screw through the PU material, pre-drill a small hole with a thin drill bit or use an awl.

For detailed instructions, please refer to the attached instructions.