IrT wheel - Footman bearing is stuck in footman cup - screw or bolt is sticking out.

As seen in the image below, the bolt has come undone.  You may alternatively have a screw connection where the screw is sticking out instead of a bolt.

Solution:

• Hold the bolt or screw with a pair of pliers
• Slide the locking ring back toward the footman as shown
• Now twist the bolt so the bearing twists out of the cup.
• Next reconnect the bolt or screw.

In the case of a screw:

In the 90’s Louet used a screw to connect the footman bearing.   We advise you replace the screw connection with a footman bolt assembly - SR0131.

In case of a bolt:

You need a lock washer between the bearing and inserted nut.    If you only have a flat washer as shown, contact your local retailer to obtain a lock washer - or you could find a lock washer at your local hardware store.

Re-connect the bolt with a lock washer and tighten.  Finish by re-attaching the footman to the footman bearing.