Team Louët @ Louet Support
- Total activity 541
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Delta Adjusting harnesses and lamm height
Height of the shaft barsShaft height should be adjusted so that with blocked shafts the warp threads run through the center of the heddle. You can check this while there is a warp on the loom. Heig...
-
Fly Shuttle Instructions for Megado and Delta
Instructions, updated 2013
-
Spinning Wheel - Bearings - Wheel is very hard to treadle
Usually this occurs because the bearings have been oiled and are now gummed up or ceased.A good cleaning is needed. Take a look at this article regarding care and maintenance Steps to check...
-
Magic Dobby - Shafts not returning to rest
The shafts not returning to rest on a Magic dobby loom is a friction problem. One possibility is that the shaft ends are coming loose. If they do, the width of the shaft increases and there c...
-
S75 / S76 / S77 V2 (DT) Instructions and information
Instructions for the S75 are shown, however, this is the same wheel as the S76 and S77 version 2 - Double treadle wheels - the only difference was the color of the finish
-
Spring 2nd warp beam instructions
Attached are the instructions for the Spring loom 2nd warpbeam
-
Megado - A shaft that should stay down, comes up when you make a shed
Possible reason: The dobby hook of the faulty shaft did not come high enough after the previous shed. The screw head should snap back above the blocking plate. Because the screw head stays against ...
-
Victoria - Changing the locking pin
If your locking pin shears off or breaks, a new pin can be ordered and replaced. Ask your local retailer for part number SR0178. Attached are the instructions to complete this repair.
-
Spring Loom Measuring tool for adding harnesses and adjusting height
Attached is the original instruction manual for the Spring loom when it was a complete assembly package. Some of the details can still be useful to Spring loom owners, and in 2020, we are seeing ...
-
Kombo Setting up the Kombo Loom
See attached instructions for setting up a Kombo 70 or Kombo 40