Dave @ Louet Support
- Total activity 538
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 298
Articles
Recent activity by Dave @ Louet Support-
Jane 2nd Warpbeam instructions
Here are the Current Jane 2nd warp beam instructions (May 2025)
-
David III / David 3 - assembly instructions
July 2023 A new David III assembly video and download the new improved assembly manual with user instructions. Improvements David III July 2023: Locking nuts on the lam cords - locking nuts are u...
-
Victoria S95/S96 Instruction Manual
Attached is the instruction manual for the Victoria wheel Here are some common spareparts Accessory Part number Standard Bobbin SA0104 brake cord - nylon cord and spring SR0102 brake...
-
S17 Irt Spinning Wheel information and Instructions
Attached are both Dutch and English instructions for the assembly of the S17 wheel. A full parts list is included in the instructions. The unfinished S17 Irish tension spinning wheel has been pr...
-
Spring 1 Relevant measurement and information
The original Spring was introduced to the market in the eighties and has undergone only minor improvements over the years. The new Spring 2 was launched in 2020, replacing the original Spring in o...
-
Jane feet length and harness / shaft height from the table during setup
In 2024 we added a shuttle race for Jane 50, 70 and eventually Jane 90. With this accessory, we discovered that the loom will not sit on a table folded due to interference with the shuttle race....
-
Jenn- E battery options - E-spinner
The new Louet E-spinner can be operated with a battery. The battery you need is a 10-18V and 15Ah battery. This size will give you about 15 hour of spinning time. This is a bigger battery th...
-
Erica relevant measurements and information
Loom Dimensions Erica 30 - 42 x 62 x 42 cm (16 1/2′′ x 24 1/2′′ x 16 1/2′′) Erica 50 - 62 x 62 x 42 cm (24 1/2′′ x 24 1/2′′ x 16 1/2′′) Folded 16 cm (6 1/4′′) high Included with the loo...
-
Erica loom weaving and assembly instructions
2023 The shaft sides of the Erica have been upgraded: instead of wood, it is now a stronger injection molded plastic. The instructions below replace the instructions in the manual for ‘Assembling t...
-
Moving a David or Spring loom
The back beam section can be folded to the castle after loosening the two eye bolts. If there is a warp on the loom, tightening the warp keeps the back beam in place.If not, use some cord or rope ...