Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
S90 Mother of all droops
If your S90 Mother of all will not tighten and continually drops down, we have a solution. The Mother of all is held in place by tightening the knob on the right side of the wheel, The original...
-
Megado Dobby 2.0 - Why doesn't Louet Software read my WIF file?
Question: Why doesn't Louet Dobby 2.0 software read my WIF-file Answer: For the Megado Dobby 2.0 software, files are accessible from a USB stick plugged into your dobby or from files on the inte...
-
Megado, Octado, Magic - problem with MAC OS 11 /12 /13 support FTDI USB to SERIAL driver
As of 20 May 2020, Apple OS 11 does not work to drive a Megado Dobby. Louet uses the FTDI VCP driver to convert USB to Serial on our circuit board. This driver has not yet been updated by our su...
-
Megado - the shed is too small.
Possible reasons: The knife of the dobby system is adjusted too high. Refer to point 7, page 12 of the instruction manual for instructions. Other possibilities -The beater is adjusted too high. -Th...
-
Megado/Octado - mechanical dobby - One of the treadles cannot be pushed down.
Possible reasons: Your foot is resting on the other treadle and you have inadvertently blocked the treadle that you want to operate. The spring for the reversing disk sits half way on the guide i...
-
Megado - When you push the shed treadle, there is no shed.
Possible reasons: 1. The cable of the treadle has become undone. 2. Computerdobby: To prevent overheating of the interface, it becomes inactive if you wait a while before making next shed. Activate...
-
Megado - The warp does not come loose from the warp beam when the warp is advanced.
Possible reasons: 1. The brake pedal has to be pushed in further. 2. The warp tension you use for your project is too low to pull the warp from the warp beam. This can happen if you make a small cl...
-
Megado - While weaving, the tension in the warp changes.
Possible reasons:1. The brake cable is not mounted properly on the disk. The cable is to be positioned neatly, next to itself on each wrap.2. The brake pedal is adjusted too high and is released by...
-
Megado - The cloth cannot be wound onto the cloth beam.
The cloth cannot be wound onto the cloth beam. Possible reasons: 1. One of the ratchets is not locked into the ratchet wheel. 2. The apron rod of the cloth beam hits one of the spring arms.
-
Megado - The roller of the mechanical dobby does not come into the next position completely when you push down the treadle.
The roller of the mechanical dobby does not come into the next position completely when you push down the treadle. Possible reasons:1. You do not push down the dobby treadle far enough.2. The cord ...