Team Louët @ Louet Support
- Total activity 557
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 305
Articles
Recent activity by Team Louët @ Louet Support-
Spinning Wheel - Footman bolt assembly
Screw in Footman ConnectorDuring the 1990's, Louet delivered wheels that had a screw attaching the footman to the main wheel. We found that some times, usually when attempting to ply, the screw wou...
-
Megado - One shaft sticks 10 mm (about 1/2") above the other shafts while it is in its rest position.
Question: One shaft sticks 10 mm (about 1/2") above the other shafts while it is in its lowest position. Probable reason: One of the shaft bar clamps has loosened on one or both sides, and by ac...
-
S45- How to change the bearings on an S45
1. Remove the bearing on the bottom of the flyer by prying up through the center hole with a screw driver.2. Remove the top bearing by pulling the bolt a little over half way out. By tilting and...
-
Megado Dobby sensors intermittent activation
Question - I’m having problems with my dobby box sensors. The upper sensor seems to work just fine, but the lower sensor doesn’t always connect to advance to the next pick. I’ve tested both sensors...
-
S75 metal rod in base
If you are missing the metal rod, labelled part "C" of the S75 double treadle connection system. This rod is stainless steel. The diameter is 6 mm and the length is 256 mm. This is part # SR0221
-
Megado - A Shaft Is Slanted
Possible reason: The clamp that fixes the shaft side to the cord has become loose. The screws in the clamps have a Phillips head, so the screwdriver that is supplied with the loom will not fit prop...
-
Megado or Octado dobby - The knife bar is too low or has slipped down
To fix this - refer to page 9 of the instruction manual. The page is attached to this solution. If you turn the eye bolt more into the treadle (Clockwise), you adjust the rest position of the knife...
-
Spinning Wheel - Louet Wheel drivebands
Louet wheels originally came with thick clear drivebands. These are no longer available, however, our current driveband will work on your wheel. There are a couple different drive bands for Louet...
-
Megado - switch block keeps coming loose
The switch block needs to be snug in place - but the small plastic nuts are hard to tighten sometimes. If your plastic nuts keep coming lose, try using “Loctite Threadlocker Blue 242 Adhesive. ...
-
Megado Dobby 2.0 Color mapping from Fiberworks into Louet Dobby software
Question: Sometimes Colors appear in the Louet software and sometimes they do not? Why? This observation was recorded by Megado user Nina Kennedy Answer: Fiberworks automatically assigns a wef...