Dave @ Louet Support
- Total activity 541
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 297
Articles
Votes on activity by Dave @ Louet Support-
Magic Dobby 2nd warpbeam
Here are the instructions for the Magic Dobby 2nd warpbeam
-
David 3 / Spring 2 - Shed is small - beater is too high
When assembling either of these looms, you set the beater height randomly and it is usually too high and usually needs to be adjusted. If the bottom shed is being deflected upwards by the beater ...
-
Megado Dobby 2.0 - solving connection problems
If the Megado Dobby 2 does not seem to work properly, and restarting the computer and the dobby does not solve the problem, the next step is to check the hardware. It’s most common that a dobb...
-
Victoria - High Speed Set
Instructions and general information Push the small whorl as far as it will go on the front of the whorl shaft. I recommend using a socket or pipe with the same diameter as the pulley to prevent cr...
-
W30 Instructions
Attached are the instructions for the W30 loom
-
Electric Drum Carder Instructions
Attached are the original electric drum carder instructions
-
Megado - electronic / dobby - Dobby knife bar dropping shafts / screw heads
Check that your dobby is physically well connected, nuts are tight, dobby is as close to the loom as it can be / should be. Your dobby's solenoids fire when the pattern asks for that harness to be...
-
Megado dobby 2.0 - I can not connect to louetwifi
The Louet wifi signal is a direct wifi signal - thus your device must be connected to it as the current wifi connection. Often a device is set to automatically connect to your home wifi signal and ...
-
Original W series instructions
Attached are various manuals for the W40 and 70 looms
-
Megado manuals (instructions)
Manuals can be downloaded from this article using links below. - Megado Loom Assembly Manual V11b including mechanical dobby - Megado Dobby 2 assembly manual (updated 2019) - Megado Dobby 2.0 Web I...