Dave @ Louet Support
- Total activity 541
- Last activity
- Member since
- Following 0 users
- Followed by 3 users
- Votes 1
- Subscriptions 297
Articles
Votes on activity by Dave @ Louet Support-
David loom tie-ups
The David loom is a sinking shed jack loom, so the shafts are pulled down. In most weaving drafts, the shaft that is raised are the shafts that are indicated in the tie up graph.In order to see y...
-
General - Tips for floorloom tie-ups
A 78 year old customer sent us a great tip for tiring up the treadles of a Spring loom. However, the same tip can also be used for the Delta of David 3. This is the tip If you need to tie-up th...
-
Spring 2 relevant measurements and information
The Spring 2 was introduced to the market in 2020 as a successor to the Spring 1. Below is a summary of features and specifications. Spring 2 - 90-8 Spring 2 - 90-12 Spring 2 - 110-8 Spring ...
-
Raddle covers
Raddle covers are new products introduced with the Spring II in Dec 2020. These covers will fit all older Spring looms as well as Megado and David looms. These covers will be available as acce...
-
Jane - Adding or moving heddles
The Jane uses 205 mm Texsolv heddles (partnr WA0214). A new bundle of heddles has four twist ties which prevent the heddles from unwinding and getting tangled. Do not throw these ties away. You...
-
Jane loom warping instructions
Attached are optional warping instructions that can be adapted fro any Louet loom
-
S51 Product Information
The S51 was made in the 1990’s. It is essentially the same as an S10 but the main wheel has 6 spokes. It uses all the same accessories as the S10 Here is a list of common accessories available ...
-
Floating Breast beam
The floating breast beam is a system patented by Louet to ensure equal warp tension each time you advance your warp. This system is available on our Spring, Delta, Octado and Megado looms. Here...
-
David 3 - sticking shaft
If your new David 3 has a shaft or two that do not want to return without help - ie, push the treadle and the treadle stays down - try increasing the spring tension under the shelf. This can also o...
-
Jane warp beam winding direction
The back beam on my Jane Loom winds in the opposite direction of any loom I have ever woven on before. Is this part of the design? The Jane Loom beam does wind on differently than most table looms....